Table of Contents
Advertisement
SUPERSERVER 6026TT-HT(R)F/HIBX(R)F/HIBQ(R)F User's Manual
Boot Sector Recovery from a Serial Port ("Serial Flash")
This process, also known as "Serial Flash," allows the user to use a serial port to
load a BIOS image for Boot Sector recovery. This feature is usually used for embed-
ded systems that rely on a serial port for remote access and debugging.
Requirements
In order to use Serial Flash for Boot Sector Recovery, you will need to meet the
following requirements.
•
The "Target system," the system that needs BIOS updates, must have a serial
port and "Serial Flash" support embedded in the BIOS image fi le.
•
The "Host system" should also have a serial port and a terminal program that
supports XModem Transfer protocol (Hyper Terminal for the Windows operating
systems, and minicom for Linux/FreeSBD, etc.).
•
A Null_modem serial cable
How to use Serial Flash for Boot Sector Recovery
1.
Connect a Null_modem serial cable between the target system and the host
system that runs the terminal program.
2.
Make sure that the new BIOS Image fi le is accessible for the host system.
3.
Start the terminal program on the host system and create a new connection.
Use the following communication parameters for the new connection.
•
Bits per second: 115200 bits/sec.
•
Data Bits: 8
•
Parity: None
•
Stop Bit: 1
•
Flow Control: None
7-28
Advertisement
Table of Contents
