Table of Contents
Advertisement
5-6
Installing Memory
CAUTION! Exercise extreme care when installing or removing DIMM
!
modules to prevent any possible damage.
Memory Support
Each X8DTT-F/X8DTT-IBXF/X8DTT-IBQF has six 240-pin DIMM slots that can
support up to 96 GB of registered ECC DDR3-1333/1066/800 SDRAM (for a total
of 192 GB in the system) or up to 48 GB of unbuffered ECC/non-ECC DDR3-
1333/1066/800 SDRAM (for a total of 96 GB in the system).
Note: Check the Supermicro web site for recommended DIMMs.
Installing Memory Modules
1.
Insert each memory module vertically into a slot following the charts below.
Pay attention to the notch along the bottom of the module to prevent inserting
it incorrectly.
2.
Gently
press down on the DIMM module until it snaps into place in the slot
(see Figure 5-3).
3.
Repeat for all DIMMs. See tables below and on following pages.
Populating Memory for Optimal Performance
O
Branch 0
3 DIMMs
P1 DIMM1A
6 DIMMs
P1 DIMM1A
Populating Memory for Optimal Performance
CPU1
Branch 0
6 DIMMs
1A
12
1A
1B
DIMMs
Chapter 5: Advanced Serverboard Setup
(Single CPU Confi guration)
Branch 1
P1 DIMM2A
P1 DIMM1B
P1 DIMM2A
(Dual CPU Confi guration)
Branch 1
Branch 3
2A
3A
2A
2B
3A
3B
5-9
Branch 2
P1 DIMM3A
P1 DIMM2B
P1 DIMM3A
CPU2
Branch 0
Branch 1
1A
2A
1A
1B
2A
2B
P1 DIMM3B
Branch 3
3A
3A
3B
Advertisement
Table of Contents
