Table of Contents
Advertisement
SUPERSERVER 6026TT-HT(R)F/HIBX(R)F/HIBQ(R)F User's Manual
1-2
Serverboard Features
At the heart of the SuperServer 6026TT are four X8DTT-HF/X8DTT-HIBXF/X8DTT-
HIBQF dual processor serverboards, which are based on Intel's 5520 (North Bridge)
+ ICH10R (South Bridge) chipset. Below are the main features of the serverboards.
Note that the features on each board are quadrupled for the server, which includes
four nodes.
Processors
Each X8DTT-HF/X8DTT-HIBXF/X8DTT-HIBQF supports two Intel® 5500/5600 Se-
ries processors in LGA1366 sockets (up to 95w). Please refer to our web site for a
complete listing of supported processors (www.supermicro.com).
Memory
Each X8DTT-HF/X8DTT-HIBXF/X8DTT-HIBQF has twelve DIMM sockets that can
support up to 192 GB of registered ECC DDR3-1333/1066/800 SDRAM, or 48 GB
of Unbuffered ECC/Non-ECC 1333/1066/800 MHz Memory (with max. 4 GB of
Registered ECC and 2 GB of Unbuffered memory per DIMM slot.) for a maximum
of 192 GB for the system. See Chapter 5 Section 6 for more details on installing
memory into the system.
Serial ATA
The South Bridge (ICH10R) of the chipset includes a Serial ATA controller for six
Gb/s SATA drives. The hot-swappable SATA drives are connected to a backplane
that provides power, bus termination and confi guration settings. RAID 0, 1, 10 and
5 are supported. Refer to the support area of our web site for procedures on set-
ting up RAID on your system.
PCI Expansion Slots
Each X8DTT-HF/X8DTT-HIBXF/X8DTT-HIBQF board has one PCI Express 2.0 x16
slot, so four PCI Express 2.0 x16 slots (for low-profi le expansion cards) are provided
in the server. In the 6026TT-HT(R)F/HIBX(R)F/HIBQ(R)F server confi guration, riser
cards have been pre-installed to support low-profi le add-on cards.
1-2
Advertisement
Table of Contents
