Dryer Care; Cleaning The Dryer Location; Cleaning The Lint Screen - Maytag BRAVOS W10201176C Use & Care Manual

3. Put the wet items on top of the drying rack. Leave space between the items so air can
reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the drying rack.
4. Close the door.
5. Press the POWER/CANCEL button.
6. Select a Timed Dry cycle and temperature (see following chart). Items containing foam,
rubber, or plastic must be dried on a clothesline or by using the Air Fluff temperature
setting.

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and
ventilation air.
7. You must select a time by pressing TIME ADJUST
needed to complete drying. Refer to the following table.
8. Press START/PAUSE.
This chart shows examples of items that can be rack dried and the suggested cycle,
temperature setting, and drying time. Actual drying time will depend on the amount of
moisture items hold.
Rack Dry
Wool Sweaters
Block to shape and lay flat on the drying rack.
Stuffed toys or pillows
Cotton or polyester fiber filled
Stuffed toys or pillows
Foam rubber filled
Sneakers or canvas shoes
*Reset time to complete drying, if needed.

DRYER CARE

Clean the lint screen before each load. The control panel has an indicator light to remind you
to clean the lint screen before each load. A screen blocked by lint can increase drying time.
IMPORTANT:
■ Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so
can cause overheating and damage to both the dryer and fabrics.
■ If lint falls off the screen into the dryer during removal, check the exhaust hood and
remove the lint.
Every load cleaning
1. The lint screen is located in the door opening of the dryer. Pull the lint screen straight up.
Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.
2. Push the lint screen firmly back into place.
+ (plus) or –
Setting
Timed Dry
Timed Dry
Timed Dry
Timed Dry

Cleaning the Lint Screen

(minus). Reset time as
Temp. Time*
(minutes)
Low 60
Low 60
Air Fluff 90
(no heat)
Air Fluff 90
(no heat)
29