Electrical Connection - U.s.a. Only - Maytag BRAVOS W10201176C Use & Care Manual

Power Supply Cord
WARNING
Use a new UL listed 30 amp power supply cord.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
1. Disconnect power.
2. Remove the hold-down screw and terminal block cover.
A B
C
3. Install strain relief.

Electrical Connection - U.S.A. Only

Fire Hazard
D
A. Terminal block cover
B. Hold-down screw location
C. External ground conductor
screw
D. Center, silver-colored
terminal block screw
E. Neutral ground wire
E
F. Hole below terminal block
opening
F
Direct Wire
WARNING
Use 10 gauge solid copper wire.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
Style 1: Power supply cord strain relief
■ Remove the screws from a 3 / " (19 mm) UL listed strain relief (UL marking on strain relief).
4
Put the tabs of the two clamp sections into the hole below the terminal block opening so
that one tab is pointing up and the other is pointing down, and hold in place. Tighten
strain relief screws just enough to hold the two clamp sections together.
A. Strain relief tab pointing up
B. Hole below terminal block opening
C. Clamp section
D. Strain relief tab pointing down
Fire Hazard
A
B
C
D
9