Dryer Care; Cleaning The Dryer Location; Cleaning The Lint Screen; Cleaning The Dryer Interior - Maytag MGDE400XW Use & Care Manual

Electronic
Hide thumbs Also See for MGDE400XW:
Table of Contents

Advertisement

Available languages

Available languages

This chart shows examples of items that can be rack dried and the
suggested cycle, temperature setting and drying time. Actual drying
time will depend on the amount of moisture items hold.
Rack Dry
Wool Sweaters
Block to shape and lay flat
on the drying rack.
Stuffed toys or pillows
Cotton or polyester fiber
filled
Stuffed toys or pillows
Foam rubber filled
Sneakers or canvas shoes
*Reset time to complete drying, if needed.
NOTE: You must remove drying rack for normal tumbling. Do not
use Sensor cycles with the drying rack.

DRYER CARE

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the
flow of combustion and ventilation air.

Cleaning the Lint Screen

Every load cleaning
The lint screen is located in the door opening of the dryer. A screen
blocked by lint can increase drying time. Clean the lint screen before
each load.
To clean
1. Pull the lint screen straight up. Roll lint off the screen with your
fingers. Do not rinse or wash screen to remove lint. Wet lint is
hard to remove.
Setting
Temp.
Time*
(Minutes)
Timed
Low
60
Dry
Timed
Low
60
Dry
Timed
Air Only
90
Dry
(no heat)
Timed
Air Only
90
Dry
(no heat)
2. Push the lint screen firmly back into place.
IMPORTANT:
Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
If lint falls off the screen into the dryer during removal, check the
exhaust hood and remove the lint. See "Venting Requirements"
in the Installation Instructions.
As needed cleaning
Laundry detergent and fabric softener residue can build up on the
lint screen. This buildup can cause longer drying times for your
clothes, or cause the dryer to stop before your load is completely dry.
The screen is probably clogged if lint falls off while the screen is in
the dryer.
Clean the lint screen with a nylon brush every 6 months, or more
frequently, if it becomes clogged due to a residue buildup.
To wash
1. Roll lint off the screen with your fingers.
2. Wet both sides of lint screen with hot water.
3. Wet a nylon brush with hot water and liquid detergent. Scrub
lint screen with the brush to remove residue buildup.
4. Rinse screen with hot water.
5. Thoroughly dry lint screen with a clean towel. Replace screen in
dryer.

Cleaning the Dryer Interior

To clean dryer drum
1. Make a paste with powdered laundry detergent and very warm
water.
2. Apply paste to a soft cloth.
OR
Apply a liquid, nonflammable household cleaner to the stained
area and rub with a soft cloth until all excess dye and stains are
removed.
3. Wipe drum thoroughly with a damp cloth.
4. Tumble a load of clean cloths or towels to dry drum.
NOTE: Garments that contain unstable dyes, such as denim blue
jeans or brightly colored cotton items, may discolor the dryer
interior. These stains are not harmful to your dryer and will not stain
future loads of clothes. Dry unstable dye items inside out to avoid
transfer of dye.
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Performance series

Table of Contents