Loading The Overlay Or Topcoat Material - DataCard ImageCard Magna User Manual

Using the printer
Replace the print ribbon cartridge
1
2
3

Loading the overlay or topcoat material

If your printer includes an optional overlay or topcoat module, the module uses supply
material. For information about material, see
This section describes the three steps of changing the topcoat or overlay material:
•
•
•
User's Guide for ImageCard® Magna™ and UltraGrafix® Magna™ Printers
Place the ribbon cartridge onto the ribbon cartridge supports (see
Make sure the cartridge is securely seated. Avoid touching the printhead cartridge
and ribbon tracker.
Figure 2-9: Replace the print ribbon cartridge
Close the swing arm, pressing it down until the push latch clicks into place.
To close the cover, lift the top slightly. Move the support up so it is parallel with the
hinges, and lower the cover.
If the printer has a locking cover, lock the cover after closing it.
i
Remove the supply cartridge
Load material in the cartridge
Replace the supply cartridge
If you change the type of supply material you use, see the e-Guide for
ImageCard® Magna™ and UltraGrafix® Magna™ Printers for more information.
2
1
"Supplies and cards" on page
2-7
Figure 2-9).
B-1.