LifeSpan DT-3 Owner's Manual page 15

Step 4: Height Adjustment/Console Harness Connections Continued
C. Attach the round connector (15) (placed in the
center tray during desktop assembly) to the
height controller port (16).
D. Connect the 7-pin rectangular connectors (14)
(one is placed in the center tray during desktop
assembly and the other is pre-installed at the
factory).
E. Re-attach the access panel to the center tray
and tighten the two screws removed in step A.
Note: Check to be sure all wires are carefully
tucked into the center tray prior to tightening
access panel screws to prevent harness
damage.
Step 5: Treadmill to Desktop Assembly
Plug the power cord into the desk recepticle (17)
and into a wall outlet. Plug the console electronics
cord into desk D-connector (18). See instructions
on page 10 for treadmill base connection.
Desk Leveling
The treadmill desk needs to be leveled prior to use.
The desk comes with 2 adjustable feet that can be
used to level the desk and elimate rocking. If the
desk is rocking on two of the feet, adjust the two
front feet until all four feet are sitting securely on
A. To raise the desk press the up or down arrow
until the desktop is at the desired height.
B. To save a height (for an environment with two
users) press the up or down arrows until the
desired height is reached.
C. Press and hold the memory preset 1 or 2 button
for 3 seconds. This will save the current height
into memory.
D. The next time the desk is used simply press the
memory preset that you previously.
15
16
17
Desk
Height
Memory
Pre-Sets
DT-7
Treadmill Desk
14
18
15