LifeSpan DT-3 Owner's Manual page 14

Step 3: Desktop Assembly
Note: It is a good idea to use two people for this part of the assembly in order to
be sure wires are properly routed and do not get pinched while installing desktop.
A. Remove the Bolts (9), Washers (10)
and Nuts (11) pre-installed in the
upright assembly posts.
B. Hold the desktop over the upright
assembly and place the desk height
control wire harness and the
console wire harness into the
center of the upright assembly (4).
Place the connector ends towards
the center of the tray for easy access
in the next steps of the assembly.
C. Set the desktop down into the
mounting brackets (E) on the
upright posts, align the mounting
holes and re-install the hardware
removed in step A.
D. Tighten the desktop mounting
bolts/nuts.
Step 4: Height Adjustment/Console
Harness Connections
A. Remove the 2 upper screws (13)
attaching the access panel for
the height adjustment control
unit.
B. Tilt down and pull the access
panel out several inches. There
are harnesses pre-attached to
the height controller, so do not
try to fully remove.
14
4
E
Do Not
Remove Screws
10
11
13
9
E