LifeSpan DT-3 Owner's Manual page 13

Step 1: Upright Support Assembly
A.
Position the left base foot (6) so the treadmill
position bumper (C) is facing inward.
B. With the workplace solutions logo facing
towards you, slide the left upright support post
over the bolts installed in the left base foot.
(Nuts and washers pre-installed in base feet)
C. Install the nuts and washers and tighten.
D. Repeat steps A through C for the right base foot
(7) and upright.
Step 2: Accessory Tray Assembly
A. Remove the 4 screws (8) pre-installed in the bottom of the upright assembly crossbar.
B. Line the holes in the accessory tray (12) with the holes in the upright assembly.
C. Install 4 screws and tighten.
A
6
12
8
DT-7
Treadmill Desk
B
C
7
13