Changing Pre-Set Options; Option Adjustment Mode - Fisher & Paykel GW711 Use And Care Manual

CHANGING PRE-SET OPTIONS

16
OPTION ADJUSTMENT
MODE
TO ENTER OPTION
ADJUSTMENT MODE
After using your Smart Drive you may want to fine
tune some of the options to suit your wash needs.
There are a number of preset options, which can be
altered.
In the EXCELLENCE Model the following pre-set
options can be changed:
• the wash temperatures.
• the rinse option on Heavy Duty, Regular and
Wool cycles.
• the cold wash to Controlled Cold.
• the number of beeps at the end of the cycle.
• the amount of water used in the Water Saver
option.
• the fill level selected by Auto Water Level.
• the Out of Balance recovery routine.
In the PRIDE Model the following pre-set options can
be changed:
• the warm wash temperature.
• the rinse option on Heavy Duty, Regular and
Wool cycles.
• the Out of Balance recovery routine.
1. Turn machine on at the wall but do not press
POWER.
Press START/PAUSE and hold down, then press
POWER.
You will hear two quick beeps and the machine
will show an unusual pattern of lights.
In this mode the lights are used to indicate the
different options available.
The diagram on page 20 shows how the lights
relate to the options you can change.
Pages 18-20 explain the different options in more
detail.
2. Use the buttons on the panel to make your
changes to the pre-set options.
3. Press POWER to return to normal mode.
4. Your Smart Drive will automatically remember your
changes.