D-Link DGS-3000 series Reference Manual page 297

DGS-3000 Series Layer 2 Managed Gigabit Switch Web UI Reference Guide
OverSize
Fragment
Jabber
Drop
Symbol
Show/Hide
Click the Apply button to accept the changes made for each individual section.
Click the Clear button to clear all statistics counters on this window.
Click the View Table link to display the information in a table rather than a line graph.
Click the View Graphic
Transmitted (TX)
To select a port to view these statistics for, select the port by using the Port drop-down menu. The user may also
use the real-time graphic of the Switch at the top of the web page by simply clicking on a port.
To view this window, click Monitoring > Statistics > Port Statistics > Errors > Transmitted (TX) as shown below:
Click the View Table link to display the information in a table rather than a line graph.
of 64 bytes and have a good CRC. Undersize packets usually indicate collision
fragments, a normal network occurrence.
Counts valid packets received that were longer than 1518 octets and less than the
MAX_PKT_LEN. Internally, MAX_PKT_LEN is equal to 1536.
The number of packets less than 64 bytes with either bad framing or an invalid CRC.
These are normally the result of collisions.
Counts invalid packets received that were longer than 1518 octets and less than the
MAX_PKT_LEN with a CRCError. Internally, MAX_PKT_LEN is equal to 1536.
The number of packets that are dropped by this port since the last Switch reboot.
Counts the number of packets received that have errors received in the symbol on the
physical labor.
Check whether or not to display CRCError, UnderSize, OverSize, Fragment, Jabber,
Drop, and SymbolErr errors.
link to display the information in a line graph rather than a table.
Figure 11-12 Transmitted (TX) window (for errors)
289