Mld Snooping Settings - D-Link DGS-3000 series Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Switch Web UI Reference Guide

MLD Snooping Settings

Users can configure the settings for MLD snooping.
To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping
Settings, as show below:
The fields that can be configured are described below:
Parameter
MLD Snooping State
Max Learning Entry Value
(1-1024)
Click the Apply button to accept the changes made for each individual section.
Click the Edit button to configure the MLD Snooping Parameters Settings for a specific entry.
Click the Modify Router Port
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Edit button, the following page will appear:
The fields that can be configured are described below:
Parameter
Query Interval (1-65535)
Max Response Time (1-
25)
Robustness Value (1-7)
Figure 4-56 MLD Snooping Settings window
Description
Click to enable or disable the MLD snooping state.
Enter the maximum learning entry value.
link to configure the MLD Snooping Router Port Settings for a specific entry.
Figure 4-57 MLD Snooping Parameters Settings window
Description
Specify the amount of time in seconds between general query transmissions. The
default setting is 125 seconds.
The maximum time in seconds to wait for reports from listeners. The default setting
is 10 seconds.
Provides fine-tuning to allow for expected packet loss on a subnet. The value of the
robustness variable is used in calculating the following MLD message intervals:
102