Table of Contents
Advertisement
DIS Digital Conference System
<seat_number>: The microphone to adjust
<Attenuation>: The desired microphone attenuation. Possible values: 0 to 6 dB, where 0 is the lowest attenuation
and 6 is most attenuation.
The CU responds to this command by returning a 'mic_attenuation' message
10.3.1.10
Request audio status
audio_status<CR>
System audio status.
The CU responds to this command by returning a list of commands for the Audio settings:
line_output_volume
audio_path
line_input_level
line_input_gain
mic_speaker_attenuation
mic_attenuation
loudspeaker_volume
audio_status_done
10.3.2
Commands from CU 6110 to External Control
10.3.2.1
Loudspeaker volume
loudspeaker_volume <volume><CR>
Volume of loudspeakers for all Conference units.
<volume> The volume of the loudspeakers ranging from -41 to 0. The value -41 indicates Off, whereas values from -
40 to 0 indicates attenuation in dB.
10.3.2.2
Line input 1 level
line_input_level_1 <level><CR>
Level of line input 1 signal.
<level> The level of line input 1 ranges from -41 to 0. The value -41 indicates Off, whereas values from -40 to 0
indicates attenuation in dB.
10.3.2.3
Line input 2 level
line_input_level_2 <level><CR>
Level of line input 2 signal.
<level> The level of line input 2 ranges from -41 to 0. The value -41 indicates Off, whereas values from -40 to 0
indicates attenuation in dB.
10.3.2.4
Line input 1 gain
line_input_gain_1 <gain><CR>
Adjust input gain of line in 1 input.
<gain>: 0 or 10
Gain can be set to 0 dB or 10 dB. 0 dB will not add any gain to the line input whereas 10 dB will add 10 dB gain to the
line input.
(for all outputs)
(for all paths)
(for all inputs)
(for all inputs)
(for all units)
(for all units)
User Manual CU 6110 rev C.docx
User Manual
64
Advertisement
Table of Contents
