Table of Contents
Advertisement
DIS Digital Conference System
<mode> "auto" (Automatic), "fifo" (First-in-first-out), "manual" (Manual) and "vox" (Voice Active)
10.2.2.9
Interrupt mode
mic_interrupt <mode><CR>
Ability for microphones to interrupt.
For CU 59XX: <mode> "on" (microphones interrupt) and "off" (microphones do not interrupt)
For CU 6110: <mode> "Same" (microphones interrupt other microphones with same or lower priority),
"Lower"(microphones interrupt other microphones with lower priority) and "off" (microphones do not
interrupt other microphones)
10.2.2.10
Mic priority
mic_priority <seat_number> <priority><CR>
This message indicates the priority of a microphone.
<seat_number>: The microphone that was adjusted
<priority>: The priority. Possible values: 0 to 5, where 0 is the lowest priority and 5 is the highest
priority
10.2.2.11
Seat State
seat_state <seat number> <seat state> <name><CR>
Information about a seat.
This information is sent from the CU to an external control application in the following situations:
When a delegate logs in
When a delegate logs out
When the seat name is modified
When the external control application requests microphone status (mic_status).
When a microphone unit becomes lost or found
<seat number> The seat number identification of a microphone unit. An integer ranging from 1 to
65535.
<seat state> The current state of the seat. This can be "active" or "passive"
<name> The seat name or delegate name. If a delegate name is available for the seat number then the
delegate name is provided. Otherwise the seat name is provided.
Example:
seat_number 12 active John Jones<CR>
This command informs about seat number 12, which is active and has the name 'John Jones' attached.
10.2.2.12
Microphone status complete
mic_status_done<CR>
Informs, that complete system status has been sent.
User Manual CU 6110 rev C.docx
User Manual
61
Advertisement
Table of Contents
