Table of Contents
Advertisement
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
9. Shift the transmission into each of the remaining
positions and verify that the appropriate icon is
displayed for the selected gear shift position (H -
High, L - Low, and R - Reverse).
NOTE: An E (Error) in the gear position icon indi-
cates no signal or a poor ground wire connection
in the circuit. Troubleshoot the harness connec-
tors, gear shift position connector, gear shift posi-
tion switch, and LCD connector.
Frame/Welds/Racks
The frame, welds, and racks should be checked period-
ically for damage, bends, cracks, deterioration, broken
components, and missing components. If replacement
or repair constitutes removal, see Section 8.
Electrical Connections
The electrical connections should be checked periodi-
cally for proper function. In case of an electrical fail-
ure, check fuses, connections (for tightness, corrosion,
damage), and/or bulbs. If an electrical component
needs to be tested for proper function, see Section 5.
Hydraulic Brake
Systems
CHECKING/BLEEDING
The hydraulic brake systems have been filled and bled
at the factory. To check and/or bleed a hydraulic brake
system, use the following procedure.
1. With the master cylinder in a level position, check
the fluid level in the reservoir. If the level in the
reservoir is not visible in the sight glass, add DOT
4 brake fluid.
www.mymowerparts.com
Back
738-420A
Back to TOC
2. Compress the brake lever/pedal several times to
check for a firm brake. If the brake is not firm, the
system must be bled.
3. To bleed the brake system, use the following pro-
cedure.
A. Remove the cover and fill the reservoir with
DOT 4 Brake Fluid.
B. Install and secure the cover; then slowly com-
press the brake lever several times.
C. Remove the protective cap, install one end of a
clear hose onto one FRONT bleeder screw, and
direct the other end into a container; then while
holding slight pressure on the brake lever, open
the bleeder screw and watch for air bubbles.
Close the bleeder screw before releasing the
brake lever. Repeat this procedure until no air
bubbles are present.
Back to Section TOC
AL681
2
AF637D
PR377A
Next
2-19
Hide quick links:
Advertisement
Chapters
Table of Contents
