Register-Level Programming; Optional Equipment - National Instruments DAQ PCI E Series User Manual

Register-Level Programming

Optional Equipment

© National Instruments Corporation
The final option for programming any National Instruments DAQ
hardware is to write register-level software. Writing register-level
programming software can be very time-consuming and inefficient, and
is not recommended for most users.
Even if you are an experienced register-level programmer, using
NI-DAQ or application software to program your National Instruments
DAQ hardware is easier than, and as flexible as, register-level
programming, and can save weeks of development time.
National Instruments offers a variety of products to use with your PCI E
Series board, including cables, connector blocks, and other accessories,
as follows:
• Cables and cable assemblies, shielded and ribbon
• Connector blocks, shielded and unshielded 50 and 68-pin screw
terminals
• Real Time System Integration (RTSI) bus cables
• SCXI modules and accessories for isolating, amplifying, exciting,
and multiplexing signals for relays and analog output. With SCXI
you can condition and acquire up to 3,072 channels.
• Low channel count signal conditioning modules, boards, and
accessories, including conditioning for strain gauges and RTDs,
simultaneous sample and hold, and relays
For more specific information about these products, refer to your
National Instruments catalogue or call the office nearest you.
1-5
Chapter 1 Introduction
PCI E Series User Manual