System Set-Up - Kenwood TK-6110 Service Manual

5. INSTALLATION PLANNING – CONTROL STATIONS
5-1. Antenna system
Control station. The antenna system selection depends
on many factors and is beyond the scope of this manual.
Your KENWOOD dealer can help you select an antenna sys-
tem that will best serve your particular needs.
5-2. Radio location
Select a convenient location for your control station radio
which is as close as practical to the antenna cable entry
point. Secondly, use your system's power supply (which
supplies the voltage and current required for your system).
Make sure sufficient air can flow around the radio and
power supply to allow adequate cooling.

SYSTEM SET-UP

Merchandise received
License and frequency allocated by FCC
Choose the type of transceiver
Transceiver programming
Are you using the external speaker?
NO
Are you using the ignition sense cable?
NO
Delivery
GENERAL / SYSTEM SET-UP
Frequency range
29.7~37MHz
35~50MHz
See page 8
A personal computer (IBM PC or compatible), programming interface (KPG-46),
and programming software (KPG-59D) are required for programming.
(The frequency and signalling data are programmed for the transceiver.)
YES
KES-4 (EXT. SP)
YES
SERVICE
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and align-
ment procedures contained in this manual.
Type
RF power
70W TK-6110 K
70W TK-6110 K2
See page 12
See page 12
KCT-18
TK-6110
3