Operating Features - Kenwood TK-6110 Service Manual

TK-6110
1. Controls and Functions
1-1. Front Panel
Display
1
MON
3 4 5
1
Volume control
Turn clockwise to increase the volume. Turn counter-
clockwise to decrease the volume.
2 / keys
Press these keys to activate their programmable func-
tions. The default settings of these keys are "Channel Up"
( ) and "Channel Down" (
3 Microphone jack
Insert the microphone plug into this jack.
4 IO (Power) switch
Press to switch the power ON. Press and hold for ap-
proximately 1 second to switch the power OFF.
5 MON key
Press MON to activate its programmable function. The
default setting of this key is "Monitor".
Press these PF (programmable function)
A key
6
keys to activate their programmable func-
7
B key
tions. The default setting of these keys is
8
C key
"No Function".
SCN key
9
Press SCN to activate its programmable function. The
default setting of this key is "Scan".
LED
10
Lights red while transmitting. Lights green while the se-
lected channel is busy. Blinks orange when you receive a
call by 2-Tone or DTMF.
1-2. Display
4

OPERATING FEATURES

Speaker
2
A B C SCN
6 7 8 9 10
).
Displays the operating Channel number,
the Channel name, and the transceiver
status.
Displays the operating channel number
and the channel status:
P indicates a Priority channel
HC indicates a Home Channel
tA indicates Talk Around mode
Flashes when a call is received by DTMF
or 2-Tone signaling. Appears during and
after transmitting if set by the dealer.
Appears when signaling squelch is
turned OFF.
Appears while scanning is in progress.
Appears when the optional scrambler
board is enabled.
Appears when the selected channel is in
the scanning sequence.
Appears when Aux is ON.
Appears when Operator Selectable Tone
is enabled.
1-3. Rear Panel
TK-6110
Antenna
connector
1-4. Microphone
PTT (Push To Talk) switch
Press and hold to transmit,
then speak into the microphone.
Release to receive.
15 pin connector
(for accessories)
Power input
connector