System Set-Up; Realignment - Kenwood NX-203 Service Manual

Merchandise received
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
NO
Are you using the speaker microphone?
NO
Are you using the voice guide & storage unit?
NO
Delivery
1. Modes
User mode
Panel test mode
PC mode
Firmware
programming mode
Clone mode
Firmware version information

SYSTEM SET-UP

Frequency range (MHz)
A personal computer, programming interface (KPG-36A/36U/36X),
and FPU (programming software) are required for programming.
(The frequency, and signaling data are programmed for the transceiver.)
YES
YES
YES

REALIGNMENT

Panel tuning mode
Data programming mode
PC tuning mode
PC test mode
RF power
TX/RX 136~174 5W
KRA-22 or KRA-26
Optional antenna
(Option)
KMC-41/KMC-42W
Speaker microphone
(Option)
VGS-1 See page 6.
(Option)
Mode
User mode
Panel test mode
Panel tuning mode
PC mode
Data programming
mode
PC test mode
Firmware program-
ming mode
Clone mode
Firmware version
information
NX-203
Type
NX-203 K
Function
For normal use.
Used by the dealer to check the fundamen-
tal characteristics.
Used by the dealer to tune the transceiver.
Used for communication between the trans-
ceiver and PC.
Used to read and write frequency data and
other features to and from the transceiver.
Used to check the transceiver using the PC.
This feature is included in the FPU.
Used when changing the main program of
the fl ash memory.
Used to transfer programming data from
one transceiver to another.
Used to confi rm the internal fi rmware ver-
sion.
3