System Set-Up; Realignment - Kenwood TK-3402(U) Service Manual

Merchandise received
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
Are you using the speaker microphone?
1. Modes
User mode
PC mode
PC test mode
Wireless clone mode
Mode
User mode For normal use.
Used for communication between the trans-
PC mode
ceiver and PC.
Data programming Used to read and write frequency data and
mode other features to and from the transceiver.
Used to check the transceiver using the PC.
PC test mode
This feature is included in the FPU.
Wireless clone Used to transfer programming data from one
mode transceiver to another.

SYSTEM SET-UP

A personal computer, programming interface (KPG-22A/22U),
and FPU (programming software) are required for programming.
(The frequency, TX power HI/LOW, and signaling data are
programmed for the transceiver.)
YES
NO
YES
NO
Delivery

REALIGNMENT

Data programming mode
PC tuning mode
Function
TK-3402(U)/3402/3407
Frequency range (MHz) RF power
TX/RX 450~520 5.0W
KRA-22 or KRA-26
Optional antenna
KMC-21, KMC-45
Speaker microphone
(Option)
2. How to Enter Each Mode
Mode
User mode Power ON
PC mode Received commands from PC
Wireless clone mode [PTT] + [Side] + Power ON (Two seconds)
3. PC Mode
3-1. Preface
The transceiver is programmed by using a personal com-
puter, a programming interface (KPG-22A/22U) and FPU
programming software.
The programming software can be used with a PC. Fig-
ure 1 shows the setup of a PC for programming.
3-2. Connection Procedure
1. Connect the transceiver to the personal computer with
the interface cable.
Note:
• You must install the KPG-22U driver in the computer to
use the USB programming interface cable (KPG-22U).
Type
TK-3402(U) K
TK-3402 K
TK-3407 M
Operation
3