Configure Module 7 - Remote Setpoint Parameters (7-Rs Or 7-N2); Configure Module 8 - Second Linear Dc Analog Output (8-A2); Configure Module 9 - Factory Service Operations (9-Fs) - Omega CN63100 Series User Manual

Configure Module 7 - Remote Setpoint Parameters (7-rS or
7-n2)
Controller returns to configuration access point (CnFP NO) if remote
setpoint option is not installed.
Display Parameter
dSP1 Remote setpoint
display scaling point
#1
INP1 Remote setpoint
input scaling point
#1.
dSP2 Remote setpoint
display scaling point
#2
INP2 Remote setpoint
input scaling point
#2
FLtr Remote setpoint
filter time constant
bAnd Remote setpoint
filter band
trnF Remote/Local
setpoint transfer
options
Range and Units Description/
(Factory Setting) Comments
-999 to 9999 Remote setpoint
(0) CN63100 display low value.
(0.0) CN63300
0.00 to 20.00 mA Key in input low
(4.00) value or Press D to
select Signal Input
method.
-999 to 9999 Remote setpoint
(1000) CN63100 display high value.
(100.0) CN63300
0.00 to 20.00 mA Key in input low
(20.00) value or Press D to
select Signal Input
method.
0 to 25 seconds 0 = off
(2)
0 to 250 0 = filter always
(5) engaged.
nor - normal Auto = Bumpless,
Auto - Automatic other modes may
trAC - Tracking bump.
(nor)

Configure Module 8 - Second Linear DC Analog Output (8-A2)

Controller returns to Configuration Access Point (CnFP-NO) if second
linear DC analog option is not installed.
Display Parameter
A2tP Second linear DC
output range
A2LO Second linear DC
output low scaling
value
A2Hl Second linear DC
output high scaling
value

Configure Module 9 - Factory Service Operations (9-FS)

Display Parameter
CodE Factory service
function code.
-27-
Range and Units Description/
(Factory Setting) Comments
0 to 10 V Set Secondary
0 to 20 mA Output jumper to
4 to 20 mA match.
(4-20)
-999 to 9999 Corresponding temp
(0) CN63100 or process value for
(0.0) CN63300 low output.
-999 to 9999 Corresponding temp
(1000) CN63100 / process value for
(100.0) CN63300 high output.
Range and Units Description/
(Factory Setting) Comments
48 - Calibrate Refer to Calibration
instrument Section for details.
66 - Reset
parameters to factory
settings
77- (twice in
succession) Reset
controller calibration
to nominal values
(Caution: This
operation results in
up to ±10% reading
error.)