Configure Module 3 - Lockout Parameters (3-Lc) - Omega CN63100 Series User Manual

Configure Module 3 - Lockout Parameters (3-LC)

Range and Units
Display Parameter
(Factory Setting)
SP Setpoint access LOC - lockout
rED - read only
Ent - enter
(Ent)
OP Output power LOC - lockout
access rED - read only
Ent - enter
(Ent)
dEv Deviation display LOC - lockout
access rEd - read only
(rEd)
UdSP Units display LOC - lockout
access rEd - read only
For CN63100 (rEd)
bdSP Blank display LOC - lockout
access rEd - read only
For CN63300 (rEd)
CodE Access code 0 to 250
(0)
Description/ Comments
Determines access to
temperature setpoint.
Determines direct
access to output power.
%P indicator illuminates
when parameter is
selected in display.
Determines display of
deviation. DV indicator
illuminates when
parameter is selected in
display.
Determines display of F
or C.
Determines blank
secondary display.
Refer to front panel
disable section for
access levels.
-23-
Range and Units
Display Parameter
(Factory Setting)
PId PID values LOC - lockout
access rEd - read only
Ent - enter
(LOC)
AL Alarm values LOC - lockout
enable * rEd - read only
Ent - enter
(LOC)
ALrS Reset alarms LOC - lockout
enable * ENBL - enable
(LOC)
SPSL SP1/SP2/Remote LOC- lockout
setpoint enable * ENBL - enable
(LOC)
trnF Automatic/Manual LOC - lockout
(user) mode ENBL - enable
select enable (LOC)
tUNE Auto-tune enable LOC- lockout
ENBL - enable
(LOC)
* Model Number Dependent
Description/ Comments
Protected Mode lockout.
Protected Mode lockout.
Hidden Mode lockout.
Hidden Mode lockout.
Hidden Mode lockout.
Hidden Mode lockout.