Configure Module 2 - Output Parameters (2-Op) - Omega CN63100 Series User Manual

Configure Module 2 - Output Parameters (2-OP)

Range and Units
Display Parameter
(Factory Setting)
CYCt Time 0 to 250 seconds
Proportioning (2)
Cycle Time
OPAC Output Control drct - cooling
Action rEv - heating
(rEv)
OPLO Output Power 0% to 100%, O1
Lower Limit (0)
(Not used in
-100% to 100%,
Manual Control)
O1 & O2
(-100)
OPHI Output Power 0% to 100%, O1
Upper Limit (100)
(Not used in
-100% to 100%
Manual Control)
O1 & O2
(100)
OPFL Sensor Fail 0% to 100%, O1
Power Level (0)
(Not used in
-100% to 100%
Manual Control)
O1 & O2
(0)
OPdP Output Power 0 to 250 seconds
Dampening (3) CN63100
(filtering) Time (1) CN63300
Description/
Comments
0 turns O1 off. Set to
zero for Linear DC
output control. Not used
for ON/OFF Control.
For both PID & ON/OFF
control.
Set OPLO < OPHI
Negative % is only valid
for O2 cooling control.
Set OPHI > OPLO
Negative % is only valid
for O2 cooling control.
Select a level to safely
control the process in
the event of input
sensor failure.
CN63100 only.
0 = off (no dampening)
Set in range of 1/50 to
1/10 of integral time.
Adjusted by Auto-Tune.
-22-
Display Parameter
CHYS ON/OFF Control
Hysteresis
tcOd Auto-tune
Dampening Code
ANtP Main Linear DC
Output Range *
ANAS Main Linear DC
Output Source *
ANUt Main Linear DC
Output Update *
ANLO Main Linear DC
Output Low Scaling
Value *
ANHI Main Linear DC
Output High
Scaling Value *
* Model Number Dependent
Range and Units Description/
(Factory Setting) Comments
1 to 250 For O1 ON/OFF
(2) CN63100 Control. Change to
(0.2) CN63300 Factory Setting prior
to Auto-Tune.
0 to 2 0 = fastest response
(0) 2 = slowest response
0 to 10 V Set linear output
0 to 20 mA range jumper to
4 to 20 mA match.
(4 to 20 mA)
OP SP = Active Setpoint
InP
SP
(OP)
0 to 250 secs 0 = Update rate of 0.1
(0) sec.
-999 to 9999 Value depends on
(0.0) ANAS assignment.
-999 to 9999 Value depends on
(100.0) ANAS assignment.