Using The Service Personnel Screen; Checking Firmware Version - Pentair INTELLITOUCH User Manual

Using the Service Personnel Screen

IntelliTouch system information such as circuit configurations are stored in the outdoor control panel
memory. System information relating to user interface settings and ordering of controllers is retained
locally at the controller (indoor control panel, MobileTouch, iS10 etc.). All system information is
backed up and updated to all indoor control panels, MobileTouch controllers, and the main outdoor
control panel periodically. If required, you can upload or down load the current system configuration to
and from the outdoor control panel and controllers. This feature is available from the Service Personnel

Checking Firmware Version

The IntelliTouch factory installed operating system software is known as firmware. There is a different
firmware program loaded on the controllers (indoor control panel and MobileTouch) and the outdoor
control panels. Every time the firmware version is changed it is assigned a new release level number
(version #). Changes are made to the firmware to either add functionality or enhance performance. If
you need to determine the firmware revision level on the system, perform the following steps.
To check the system firmware version:
Getting There
MENU SETUP ADVANCED
Go to the Advanced screen.
1. From the Advanced screen, press buttons 2 and 4 at the same time. The Service Personnel screen is
displayed.
2. Press the button next to System Version Info. The firmware version is displayed for the Indoor
Control Panel (UIC) and Outdoor Control Panel (UOC).
4. Press Back to exit.
5. Press Exit to return to the main screen.
Note: Different controllers may have different revision levels depending on when they were installed.
To determine the firmware version of each controller repeat the above steps for each controller.
CIRCUIT NAMES
CIRCUIT FUNCTIONS
CONFIGURE VALVES
SPA, RF, & PHONE REMOTES
MENU/SETUP/ADV
BACK
Press both buttons at the same time to
access the Service Personnel screen
CALIBRATE
EXIT
SEND IMAGE TO OUTDOOR
IntelliTouch Control System User's Guide
®
85