Assigning Additional Expansion Centers - Pentair INTELLITOUCH User Manual

Assigning Additional Expansion Centers

4. Buttons 2, 3, and 4 LEDs will be on. Do one of the following:
• If this is the first Expansion Center, press Button 2.
If this is the second Expansion Center, press Button 3.
•
If this is the third Expansion Center, press Button 4.
•
Note: Do not set more than one Expansion Center to the same number. These numbers correspond
with the numbered display screens on the Indoor Control Panel and MobileTouch wireless controller.
5. The red LED will be on above the selected button number.
6. Repeat the steps above for each additional Expansion Center.
7. After each Expansion Center is enabled, press Reset on the Outdoor Control Panel. Wait until the red
Auto and Pool LED is lit. The system is ready for normal operation.
Main IntelliTouch
Load Center
(i5+3, i5+3S, i7+3, i9+3,
i9+3S, i10+3D)
Number 1
Note: Expansion Centers may be a Load Center or Power Center. Connections from the Main Load
Center to an Expansion Center is via the COM port on the Personality board.
Button
2 3 4
Power Center
(i5x or i10x),
(P/N 521214 with
IntelliChlor SCG
transformer)
(P/N 521216 without
IntelliChlor SCG
transformer)
Number 2 Number 3
Additional
Additional
Expansion
Expansion Center
Center
(3 maximum)
Number 4
IntelliTouch
Note: For details about
selecting the Indoor Control
Panel display that are
connected to additional
Expansion Centers, see
page 35.
Control System User's Guide
®
27