Feature: Color Set; Fixed Colors Screen; Fixed Colors: Hold/Recall Feature - Pentair INTELLITOUCH User Manual

Setting up IntelliBrite LED lights

Feature: Color Set

The "Color Set" SAm Style feature allows any combination of up to 12 IntelliBrite lights, and SAm,
SAL and or Fiberworks lighting (see page 42) to be preset to specific colors. To enable this feature,
first select the light color from the "Colors" screen, then press the button next to "Color Set" to change
the lights to the selected color. Note: If the light was not previously on, after pressing the COLOR SET
button, no illumination will occur for approximately six (6) seconds followed by the "COLOR SET"
feature selection. If the light was previously on, after pressing the COLOR SET button, the previously
selected color will momentarily illuminate, no illumination will occur for approximately six (6) seconds
followed by the "COLOR SET" feature selection.

Fixed Colors Screen

There are five (5) fixed colors to choose from to create a spectacular underwater lighting effect. The
fixed colors are: Blue, Green, Red, White and Magenta. You can switch each light on or off from
this screen (see above) by pressing the button next to the name of the color light. Note: If the light
was not previously on, after pressing a color button, no illumination will occur for up to ten (10)
seconds (depending on the selection), then a white light will momentarily illuminate, followed by the
color selection. If the light was previously on, pressing the color button will momentarily illuminate
the previously selected color before changing to the
selected color mode.
To select a fixed color:
1. To access the IntelliBrite fixed "Colors" screen
from the Main screen, press the Lights button on
the bottom of the screen, then press the right side
button next to "COLORS."
2. To activate a color, press the button next to the
name of the color.
Fixed Colors
Hold
Swim

Fixed Colors: Hold/Recall Feature

Use the "Hold" and "Recall" feature to capture and save the selected color and recall it at a later time.
Note: After pressing the HOLD or RECALL button, no illumination will occur for up to 10 seconds, then
a white light will momentarily illuminate, followed by the saved color.
BLUE WHITE
GREEN MAGENTA
RED
HOLD INTELLIBRITE RECALL
SWIM SAM STYLE COLOR SET
LIGHT/INTELLIBRITE/COLORS
BACK EXIT
(Continued)
SPA LIGHT
SPA SAL
MODES INTELLIBRITE
NEXT GROUP
SAVE ALL ON
WARNING - During the off/on switching
process, before the selected color is
displayed, no illumination will occur.
Fixed Colors
This operating mode is normal during
the switching process. During this
Recall
period the pool and spa will be dark
Color Set
and precautions should be taken to
avoid unforeseen accidents. Failure
to observe this warning may result in
serious injury or death to pool and spa
POOL LIGHT
POOL SAM 1
Press
COLORS
Colors
CONFIGURE
button
LIGHTS
for Fixed
ALL OFF SYNC
Colors
selection
IntelliTouch Control System User's Guide
®
49