Configuring Remote Control Button Circuits (Is4, Spacommand, Spa Side Remtoe, Qt4 Quicktouch, And Phone Remote) - Pentair INTELLITOUCH User Manual

Configuring Remote Control Button Circuits
(iS4, iS10, SpaCommand Spa Side Remote, Quick-
Touch (QT4) and phone remote)
From the spa side remote screen you can configure the iS4, iS10 and
®
SpaCommand buttons to control different pool/spa functions, including
IntelliFlo VF 3050, VS 3050 and VSF+SVRS pump speeds. Up to two iS4
remotes, and four iS10 and SpaCommand remotes can be connected to an
IntelliTouch system. To assign a circuits to spa-side remote buttons:
1. Press the button next to
CONFIGURE 10 BUTTON SS's or CONFIGURE QUICKTOUCH
to select the remote.
• For iS4: Press the top button to access the setup screen for iS4 #1
and iS4 #2 . See note below if multiple iS4 remotes are installed.
• For iS10 and SpaCommand: Press top button to select 10
BUTTON SPA SIDE #1 for the first iS10 or SpaCommand remote.
Choose which one of the four remotes you are configuring, 10
BUTTON SPA SIDE #1 #2, #3 or #4. See note below if multiple
iS10 or SpaCommand remotes are installed.
• For QuickTouch: Press the button next "CONFIGURE QUICKTOUCH"
to access the setup screen.
2. On the next screen: Press the button next to the circuit you wish
to assign. A small arrow is displayed pointing to the name of that
circuit. Use the Up and Down buttons at the bottom of the screen
to scroll through the iS10 or iS4 circuit names (SPA, POOL, AUX
1-8, HEAT BOOST, HEAT ENABLE, INCREASE PMP SPD,
DECREASE PMP SPD, NONE). For QuickTouch: (SPA, POOL,
AUX 1-4, POOL). Note: When assigning buttons to "Increase" and
"Decrease" the IntelliFlo VF (GPM), VS (RPM) and VSF+SVRS
(RPM/GPM). Each press of the assigned button increases or
decreases the pump's "step" flow rate or speed until the GPM or
RPM is reached as specified in the "SPA SIDE INFLO CONTROL" screen
(on the 10 Button SS screen). Be sure to set the
pump address number (in the IntelliFlo screen) for the pump you
wish to control.
Note: For systems with four iS10/SpaCommand remotes, adding one or two
iS4 remotes will affect button function assignments as follows: Assigned button
functions 1 - 4 on iS4 #1 are linked with the same functions to buttons 1 - 4 (top row) of
iS10 #4. Also, buttons 1 - 4 on iS4 #2 are linked to buttons 6 - 10 (bottom row) of iS10
#4. For example, button 6 on the bottom row of iS10 #4 is linked to button 1 of iS4 #2,
button 7 on iS10 #4 is linked to button 2 of iS4 #2, etc.
CONFIGURE iS4'S or
LED
iS4 spa side remote
iS4 circuit/button setup
INC PMP SPD
DEC PMP SPD
iS10 circuit/button setup
INTELLIFLO PUMP # 1
STEP SIZE 10 GPM
SPA SIDE IFLO CONTROL
screen
IntelliTouch Control System User's Guide
®
81