Setting The Egg Timer Function - Pentair INTELLITOUCH User Manual

Setting the Egg Timer Function

The "Egg Timer" feature lets you manually switch on equipment and switch off automatically after a
specified time. You can set this timer feature for other equipment such as lighting, the spa, or the spa
jets. Equipment can be programmed to be switched on for one minute to 24 hours. You can also use
the "Don't Stop" feature to override the 12 hour default switch off time, and run continuously until
manually switched off.. If you have never set the timer for a specific piece of equipment, the factory
default time is set to 12 hours.
If you have a power outage, this feature will not switch the equipment back on, you need to use set the
system in "Service" mode at the outdoor control panel center to switch the equipment back on. For more
information, refer to "Using the Service Personnel Screen" on page 85.
Go to the PROGRAM/SELECT equipment screen. From this
screen you can select SPA, POOL or any of the AUX equipment
circuits to program. The following example describes how to
program the spa equipment using the "Egg Timer" feature:
1. To program the spa filter pump and heater to switch on and
off at a specific time, press the button next to SPA to access
the "Program/Select" screen. If this is the first program, the
program counter displays (1/0). After this program is saved,
(1/1) is displayed (see step 6). Up to 99 total programs may
be created for all circuits combined.
2. Press the left side button next to HOURS until EGG TIMER
is displayed. (EGG TIMER is displayed one press after 11:00
PM).
3. Press the left side button next to HOURS (under EGG
TIMER) to set the count down run time in hours (from 00:00
to 23:00 hours). You can also select "DON'T STOP" to run
the circuit continuously until switched off manually. "DON'T
STOP" is displayed one press after 23:00.
4. Press the right side button next to MINS to set the run time
minutes.
Note: Press the button under CLEAR to reset the default settings.
5. For the "Egg Timer" feature ALWAYS is displayed, indicating the program will run and automatically
shut-off in the specified time.
6. Press Save to save the current program. The program counter displays (1/1) indicating that you have
saved one (1) program for the selected circuit.
7. Press the Back button to return to the SPA, POOL and AUX equipment selection screen to program
other equipment.
8. Press the Exit button to return to the main screen.
MENU/PROGRAM/SELECT
BACK DISPLAY EXIT
SPA
SS_NO 1/0
EGGTIMER
ALWAYS
MENU/PROGRAM/SPA
SMART
START
IntelliTouch Control System User's Guide
®
17