Warning: The following procedures require the power to be on. Take
extreme caution when working around live electrical components.
Check Power at the MCB
1. Set the multi-meter to read DC voltage and take a reading between white and black wires (Fig. 9). The leads must
be in contact with the pin in the plastic connector to get a proper reading. There should be approximately 12 volts
DC.
If there is no voltage, and the diagnostic LED's are lit, replace the MCB.
•
If there is voltage, continue on to Verify Voltage to the Screen or PVS CCB.
•
STAR TRAC FITNESS
Troubleshooting
Fig. 9
6 of 7
637-1381 Rev: A