Check The Fuse On The Mcb - Star Trac E-TRe Troubleshooting Manual

If there is no power, replace the power cable then test the unit.
•
If the MCB LED's still are not on, continue on to section: Check the Fuse on the MCB.
•

Check the Fuse on the MCB

1. Turn the treadmill off.
2. Remove fuse F1 from the MCB (Fig. 7) and with the multi-meter, check the fuse (Fig. 8). There should be
continuity across the fuse.
If the fuse has no continuity or is visibly burnt, replace the fuse. It is a 250v .4 amp (400 milliamps) slow blow
fuse. Once replaced test to see if the MCB powers up.
If the MCB does not power up after replacing the fuse, replace the MCB.
•
If the fuse is good and the MCB won't power up, replace the MCB.
•
STAR TRAC FITNESS
Fig. 7
Troubleshooting
Fig. 6
4 of 4
Fig. 8
637-1378 Rev: A