Verify Voltage to the Screen or PVS CCB
1. Set the multi-meter to read DC voltage. Insert the leads into the plastic connector (Fig. 5). The leads must be in
contact with the pin in the plastic connector to get a proper reading. There should be at least 11 VDC.
If the voltage is less than 10.4 volts DC, replaced the power cable.
•
If the voltage is between 10.5 and 10.9 volts leave the multi-meter leads in the plastic connector and continue
•
to Adjusting the Power Supply Potentiometer
Adjusting the Power Supply Potentiometer
1. Locate the potentiometer (pot) on the power supply (Fig. 6).
2. Using the small flathead screwdriver, make small adjustments in the counter-clockwise direction and watch the
multi-meter. Turn the pot till the meter reads 11.2 volts.
STAR TRAC FITNESS
Troubleshooting
Fig. 5
Fig. 6
4 of 7
637-1381 Rev: A