Warning: The following procedures require the power to be on. Take
extreme caution when working around live electrical components.
6. Insert the multi-meter leads into the cables (Fig. 5) then turn the power on. The voltage reading should be like
those noted in step 4.
a. If there is voltage, replace the EMI filter. Then test the treadmill to see if the MCB will power up.
b. If there is no voltage, replace the on/off switch and/or the onboard circuit breaker. Then test the
treadmill to see if the MCB will power up.
If the MCB will not power up after replacing components, continue on to section: Verifying Power Going to the MCB.
Warning: The following procedures require the power to be on. Take
extreme caution when working around live electrical components.
Verify Power Going to the MCB
1. With the power on, check the voltage on P6 on the MCB (Fig. 6). This is the main power to the MCB from the EMI
filter.
The readings should be between:
110 Volt Treadmills – 110 VAC – 120 VAC
•
220 Volt Treadmills – 208 VAC – 240 VAC
•
STAR TRAC FITNESS
Fig. 4
3 of 4
Troubleshooting
Fig. 5
637-1378 Rev: A