Circuit Boards Info - Star Trac E-TRe Troubleshooting Manual

You may encounter some MCB's where the connector that delivers power to the PVS or embedded head (see actual
location of this connector in Fig. 7 below) has 6 pins but the connector that plugs in is only a 4 pin connector. In this case
plug the connector into the middle and keep one pin on the left and one pin on the right free (Fig. 8). Carefully cut the two
outer pins to prevent future confusion.
Always turn the unit off and unplug it from the wall power outlet before working on any electronic component.
STAR TRAC FITNESS
General Information
Fig. 7
Fig. 8
8 of 8
637-1338 Rev: B