Checking The Power Supply And Power Cables - Star Trac E-TRe Troubleshooting Manual

Checking the Power Supply and Power Cables

This document contains troubleshooting for both Version 1 and Version 2 MCB's.
These procedures will require the motor shroud to be removed.
Warning: The following procedures require the power to be on. Take
extreme caution when working around live electrical components.
If an embedded treadmill display will not power up, yet there appears to be power on the power supply, follow the steps
outlined in this document.
Tools Needed:
Phillips screwdriver
•
Multi-meter
•
Small flathead screwdriver
•
Note: The procedures in this troubleshooting document require the power to be on and the drive motor shroud to be
removed. Take extreme caution when working around live electronic components.
STAR TRAC FITNESS
Troubleshooting
E Series Treadmills
Version 1 MCB
1 of 7 637-1381 Rev: A