System Config - Yamaha Nexo NXAMP4X4 User Manual

System config

This menu allows changing between several speaker setups inside a same family or even
through any family, even if this last solution is not recommended. Same family means that
same cabinet are connected to same outputs of the amplifier. Mainly this menu is for
comparing quickly to setup (Wideband and Crossover for example) without restarting the
amplifier. To enter this menu, go to the OPTION menu, and display Bellow is a picture of
this menu. First step to change the input patch is to go to the OPTION menu (see above),
then select the sub-menu "1.Systm Config".
201. S1210 XO
Select one speaker setup by turning the wheel till the setup number appears blinking on
the LCD screen (in this example, you can toggle between the Crossover (Xover) and the
Wide setup). Then depress the "B" button (OK). Once the setup is loaded, the amplifier will
go back to the default screen. If you don't want to change the current speaker setup,
simply press the "A" button (Back).
If you want to recall a setup from another family, you should first go to the last setup of
the current family, meaning that the setup number cannot increase when turning the
wheel. You will then see the mention "All" appearing in front of the 'Select 4' switch.
201. S1210 XO
If you press the select 4 button, the previous display (without "All" on screen) will be
displayed, but this time all the setup will be available when turning the wheel.
N.B.: When changing setups inside the same speaker family, the settings of the unit (input
patch, delay, gain...) are kept. If you choose another family, settings will go back to the
default values.
MENU DESCRIPTION
RS15 CD 80
RS15 CD 80
PAGE 45 OF 91
OK
All OK