Replacing The Bezel; Replacing The Side Cover - IBM IntelliStation A Pro 6224 User Manual

4. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
5. Thread the cable through the rope clip and around an object that is not part of
6. If you have other options to install or remove, do so now; otherwise, replace the
7. Reconnect the external cables and power cords. Turn on the attached devices,

Replacing the bezel

Complete the following steps to replace the bezel:
1. Insert the two tabs on the bottom of the bezel into the matching holes on the
2. Push the top of the bezel toward the server until the two tabs at the top of the

Replacing the side cover

If you removed the support bracket, reinstall it before you replace the side cover.
See "Removing and installing the support bracket" on page 38.
Note: The rear adapter-retaining bracket rests against the computer side cover.
You might find it easier to lay the computer on its side to replace the side cover.
Complete the following steps to replace the side cover:
1. Make sure that all cables, adapters, and other components are installed and
2. Install the side cover by placing it into position on the computer. Make sure that
or permanently secured to the building structure or foundation and from which
the cable cannot be removed. Fasten the cable ends together with a lock. After
you add the security cable, make sure that it does not interfere with other
cables that are connected to the computer.
Rope clip
side cover (see "Replacing the side cover").
and turn on the computer.
server chassis.
bezel snap into place.
seated correctly and that you have removed all work tools or parts from inside
the computer.
the lip on the bottom of the cover rests on the ledge on the bottom of the
chassis before rotating the cover up to the vertical position. Press down on the
cover-release latch as you slide the side cover forward to lock the side cover.
Chapter 4. Installing options
63