IBM IntelliStation A Pro 6224 User Manual page 62

Installing a drive in bay 3
Note: Only a 3.5-in. device can be installed in bay 3.
Complete the following steps to install a drive in bay 3:
48
IntelliStation A Pro Type 6224: User's Guide
1. Read the safety information beginning on page vii, the guidelines in "Handling
static-sensitive devices" on page 33, and the documentation that comes with
your drive.
2. Make sure that you have all the cables and other equipment specified in the
documentation that comes with the drive.
3. Check the instructions that come with the drive to determine whether you need
to set any switches or jumpers on the drive. If you are installing a SCSI device,
make sure that you set the SCSI ID for that device.
4. Turn off the computer and all attached devices; then, disconnect all external
cables and power cords.
5. Remove the side cover (see "Removing the side cover" on page 37).
6. Remove the front bezel (see "Removing the bezel" on page 39).
7. Remove the support bracket (see "Removing and installing the support
bracket" on page 38).
8. Use a screwdriver to pry the filler panel and EMC shield away from the
computer.
Note: If you are installing a drive that contains a laser, review the following
safety precaution.