LIP-6812 & LIP-6830
Local UDP Port
5060
[
] [CLR ] [ OK ]
5) Press the [ OK ] Softkey to save your Configuration.
6) Press the
Changing the Local UDP Port requires a reboot of the LIP-6812/LIP-6830; when you
leave the menu, you will receive a Reboot notice.
3.5.2.6 RTP Start Port
When a SIP call is established, digitized voice signals are sent and received in Real-Time
Protocol (RTP) packets. The port used for RTP packets is usually 23000, but a different port
may be defined.
To assign an RTP port:
1) Press the
Section 3.3 Lock/Unlock Configuration).
2) Press
button, or move cursor to 2.SIP Configuration using the [Next]/[Prev] Softkeys,
and press the [ OK ] Softkey.
3) Press
button, or move cursor to 8.RTP Start Port using the [Next]/[Prev] Softkeys, and
press the [ OK ] Softkey.
4) Input the RTP Start Port for the LIP-6812/LIP-6830 using the dial pad.
RTP Start Port
23000
[
] [CLR ] [ OK ]
5) Press the [ OK ] Softkey to save your Configuration.
6) Press the
Changing the RTP Start Port requires a reboot of the LIP-6812/LIP-6830; when you
leave the menu, you will receive a Reboot notice.
3.5.2.7 Proxy Registration
If Proxy Registration is set to [Yes ], the LIP-6812/LIP-6830 will register with the appropriate
Call or Proxy Server upon initial power-up, during a reboot and at periodic intervals based on
the Registration timer (refer to Section 3.5.2.8).
To enable Proxy Registration:
button to exit from the menu.
button. If the LCD Menu is locked, use the unlock procedure (refer to
button to exit from the menu.
35
Installer Guide
June, '07