LG LIP-6812 Installer's Manual page 119

LIP-6812 & LIP-6830
line1_type ~
linen_type
line_bla_prim ~
linen_bla_prim
line1_extension ~
linen_extension
line1_acd_activity ~
linen_acd_activity
line1_acdgroupid ~
linen_acdgroupid
ROUTE add
ringer_off
(Optional) Line type can be configured by ITSPs.
Valid values are as follows:
• private — A line that is only presented with any call
appearance that is only visible and accessible through the
original endpoints involved in setting up the call.
• shared — a line that is only presented with any call
appearance that is visible and optionally accessible through
the original endpoints in the call as well as an authorized set
of other endpoints in the network.
• dss — a shared line except no outgoing call access is
provided. The users can make one-touch calling to covered
extensions (Direct Station Selection) and answer incoming
calls.
The externsion number is set in the linen_extension field.
Default is private.
(Optional) For BLA Line types, specifies the Name/SIP User
Id associated with the LIP phone if it is different from the
Name (linen_name).
The n variable represents a phone line.
Max 50 characters are available.
(Optional) When a line (linen_type) is assigned as a DSS,
the associated extension number must be assigned.
The n variable represents a phone line.
(Optional) Whether to activate ACD agent for the specified
line. Valid values are disable and enable.
Default is disable.
(Optional) Specifies the ACD Agent Group ID for line1 to n,
where n is the line number to the max_line_num field.
Note : (Optional) Routing table can be used to manage the dial plan in the
LIP Phone. As soon as a digit pattern matching the routing table entry is
found, the call set-up process starts.
Note: 0 to 9, '*' and '#' defines the prefix digits and the number of digits
required to follow each prefix
'~' is a wild card character that match any multiple characters.
'?' Any dialed digit.
'.' represents "virtual dial tone"
',' locates the position of a 3-second pause in the prefix number
Must be SIP.
intf
Must be 0.
port
Specifies the destination prefix number.
nums
Valid values are 0 to 9, '*', '#', '~', '?', '.' or NULL.
(Optional) Specifies the number of prefix digits to be stripped
before forwarding the collected digits to the destination. Valid
trunc
values are 0 to 31.
(Optional) Specifies the number to add in front of the phone
pre
number. Valid values are 0 to 9, '*', '#', '.', '~' or NULL.
(Optional) Specifies the number to add at the back of the
post
phone number. Valid values are 0 to 9, '*', '#', '.', '~' or NULL.
(Optional) Specifies the position of prefix table which has the 3
seconds pause before sending the call. The ',' locates the
pause
position of the 3 seconds pause in the prefix number. Valid
values are '?', ',' or NULL.
(Optional) Specifies the ip-address of phone to assign the
ip-addr
prefix number without regard to the proxy address..
(Optional) Turn on or off the ring signal when receiving
inbound call.
D-
6
Installer Guide
June, '07