Lifecycle 9100 and 9500HR Series Exercise Bikes
How To...REMOVE AND REPLACE THE DIGITAL HEART RATE SENSORS
Installing the new Lifepulse digital heart rate sensors:
Kit Number
Product
•
GK2G-OOOO2-0001
(small radius)
GK2G-OOOO2-0002
( large radius)
Life Fitness 9100HR and 9500HR Treadmills
Life Fitness 9500HR Cross-Trainer Total Body
Lifecycle 6500HR Exercise Bike
Lifecycle 8500 Exercise Bike
Life Fitness 9500HR Stairclimber
Lifecycle 9500HR Exercise Bike
Lifecycle 9500HR Recumbent Exercise Bike
Lifecycle 9500HRT Exercise Bike
3.
Plug the Faston connector (red or white wire) to the back of the new, pre-assembled signal output sensor
assembly (this will be the assembly without the screw access holes in the sensor) and locate it into position. This
sensor will be the sensor on which the palm rests during use.
4.
Plug the Faston connector (black or green wire) to the back of the new, pre-assembled ground sensor
assembly (this will be the assembly with the screw access holes in the sensor) and locate it into position. This is
the sensor on which the fingertips rest during use.
5.
Install the two screws through the access holes in the ground sensor and torque to 5 - 7 in Ibs .
18
•
•