Drive Belt - Life Fitness Lifecycle 9100 Service Manual

Lifecycle 9100 and 9500HR Series Exercise Bikes
How To...REMOVE AND REPLACE THE DRIVE BELT
Tools Required: Two Standard screwdrivers, long-nose pliers, or E-ring tool
1. Remove the Housing. Refer to "How To...." in this section.
2. Remove the Altemator Belt. Refer to "How To ...." in this section.
3. Loosen the hex bolt on the bracket assembly and slacken the belt.
4. Remove the three FLAT INNER E-RINGS and the BENT OUTER E-RING. Use either two screwdrivers, long-
nose pliers, or an E-Ring tool.
CAUTION! THE E-RINGS ARE UNDER LOAD. PLEASE REMOVE THEM SLOWL Y AND CAREFULL Y.
5. From the BELT side, use a center punch and a small hammer to tap out the SHAFT from the PULLEY
BRACKET.
6. Pull the PULLEY forward and out of the bike frame and remove the BELT.
7. Reassembly is the reverse of removal.
•
Loosen
Hardware
4
Remove
E-Rings
-.
-
•
•