Stabilizer Bar - Life Fitness Lifecycle 9100 Service Manual

Lifecycle 9100 and 9500HR Series Exercise Bikes
How To...REMOVE AND REPLACE THE STABILIZER BAR
• Tools Required: 1/2 inch wrench, short length of 2x4 board or a small box of same size to support bike
1. Raise the rear of the bike and support it with a piece of 2x4 board under the rear of the bike and in front of the
STABILIZER BAR.
2. With the 1/2 wrench, remove the two STABILIZER BOLTS from the bottom of the STABILIZER BAR. Remove
the STABILIZER BAR from the bike frame.
3. Install the new STABILIZER BAR and tighten the bolts to a torque of 25 to 30 in. Ibs. The stabilizer bar must be
flush against the rear frame of the bike.
4. After placing the bike in the intended location for use, check the stability of the Lifecycle exercise bike. If the
bike is not level, then tum the two LEVELERS as necessary to eliminate all rocking motion.
Leveler/
•
•
,
\
I
\
Slabilizer Bolt
A
25-30 in Ibs
Stabilizer Bar
23