Life Fitness Lifecycle 9100 Service Manual page 110

Lifecycle 9100 and 9500HR Series Exercise Bikes
INSTALLATION INSTRUCTIONS Model
LC91 00
Step 7
Slide the COLLAR (#4) down until it completely covers the
HANDLEBAR ASSEMBLY HARDWARE and the HANDLEBAR POST.
Secure the COLLAR by squeezing the sides and pushing firmly
downward.
Step 8
There is a large hole in the rear of the DISPLAY CONSOLE (#6)
through which you can see a 16-PIN CONNECTOR and a 3-PIN
CONNECTOR. These correspond to the respective CONNECTORS
on the WIRE HARNESS protruding from the top of the HANDLEBAR.
Properly align the locking tabs of the 16-PIN CONNECTOR on the
WIRE HARNESS with the 16-PIN CONNECTOR on the back of the
DISPLAY CONSOLE, then snap them together. Next, align the locking
tabs of the 3-PIN CONNECTOR on the WIRE HARNESS with the 3-
PIN on the back of the DISPLAY CONSOLE and push them together
until they SNAP into place.
•
3-PIN HEART RATE
CONNECTOR
16-PIN
CONNECTOR
Step 9
Feed the WIRE HARNESS back into the HANDLEBAR
TUBE. Attach the DISPLAY CONSOLE to the
HANDLEBAR ASSEMBLY using the four CONSOLE
SCREWS (#2) and a Phillips screwdriver. Tighten the four
SCREWS in a crisscross pattem. 1 ><.4
3 2
CAUTION!: BE CAREFUL NOT TO OVERTIGHTEN THE
SCREWS.
•
Step 10
To install the 9-VOLT ALKALINE
BATTERY (#8) found in the parts
bag use a Phillips screwdriver to
remove the screw from the back
door. Gently pull the BATTERY
WIRES from the back of the
DISPLAY CONSOLE and connect
them to the 9-VOLT ALKALINE
BATTERY. Carefully, tuck the
BATTERY WIRES back into the
DISPLAY CONSOLE and set the
BATTERY in place.
Re-install the BATTERY DOOR by
inserting the bottom tab of the
BATTERY DOOR into the
corresponding slot in the DISPLAY
CONSOLE. Push the DOOR into
place and tighten the screw with a
Phillips screwdriver.
8
NOTE: ONL Y USE AN ALKALINE TYPE BA TTERY. USE OF ANY OTHER
TYPE BA TTERY MA Y RESUL T IN A MALFUNCTION OR DAMAGE.
BATTERY WIRES
HILLIPS SCREW
•