Psion Teklogix 7535 G2 User Manual page 228

Chapter 5: Configuration
Options
Good Scan Beep And Bad Scan Beep
These parameters determine whether or not the 7535 G2 emits an audible scanner
'beep' when a good (successful) scan or a bad (unsuccessful) scan is performed. Set
these parameters to either ON to enable the beeper or OFF to disable it.
Soft Scan Timeout
This parameter is used by the SDK "Scan" function (soft-scan: starting a scan
session via the SDK function, instead of a physical user trigger press). The value
assigned to this parameter determines the soft-scan timeout from 1 to 10 sec.
(default is 3 sec.).
Scan Log File
If this parameter is enabled, the input bar code and the modified/translated output
bar code are logged in the file \Flash Disk\ScanLog.txt. Keep in mind that if Scan
Log File is enabled, there is a slight performance reduction when performing
multiple scans since the log file is written to persistent storage.
196 Psion Teklogix 7535 G2 Hand-Held Computer User Manual