Disconnecting From A Network; Shutting Down The Wireless Wan User Interface - Psion Teklogix 7535 G2 User Manual

When "Ready to connect" is displayed in the Status field, the Connect Data button
is enabled.
• Tap on the Connect Data button.
The progress of the connection is tracked in the Status field.
• PPP link to modem active.
• Authenticating user.
• User authenticated.
• Connected.
Note: Keep in mind that these states may be displayed fairly quickly if the
progress of the connection is rapid.
When the connection state reaches PPP link to modem active, the taskbar icon
changes to indicate an active connection. The Connect Data button changes
to Disconnect.
E.1.2.1 Disconnecting From A Network
To disconnect from the network:
• Tap the stylus on the Disconnect button, and then on OK.
When the computer's network connection is severed, the Status field displays
"Ready to connect".
The signal strength is displayed in the main Wireless WAN screen, even while a
connection is active. The Rx bytes and Tx bytes fields estimate the amount of data
transmitted and received, respectively.
E.1.2.2 Shutting Down The Wireless WAN User Interface
While it is not usual to shut down the GSM/GPRS user interface, you can
accomplish this by tapping on the File menu and choosing the Exit command at the
bottom of the main Wireless WAN dialog box
Note: Once you've shut down the user interface, you can only enable the radio
by opening the Control Panel and tapping on the Wireless WAN icon to
display the Wireless WAN dialog box.
Appendix E: Wireless Wide Area Network (WWAN)
Psion Teklogix 7535 G2 Hand-Held Computer User Manual
Establishing A Connection
E-5