Psion Teklogix 7535 G2 User Manual page 150

Chapter 5: Configuration
The Devices Tab
Wait for the 7535 G2 to complete its scan (approximately 20 seconds). When
scanning starts, the Scan button will change to Stop—if necessary, you can
tap on this button to stop the process. Once scanning is complete, all discovered
devices will be displayed in the list box, with Name, Address, Active status,
and PIN information.
Note: During the scanning process, addresses are located first, followed by
names. Only the names of devices that are within the Bluetooth radio cov-
erage range will be retrieved.
The Active column indicates whether any service is activated for that device. When
a service is activated, the device is displayed in the list even when it is not detected
during the scan.
The PIN column indicates whether you have a PIN (password) set for the device.
At this point you can either query for services or set the PIN for each device. Once
you highlight a device in the list box, both the Services and Set PIN buttons
become available.
Services
A discovered device may display several service profiles that it can use to
communicate, and you will want to activate the type you need. Supported profiles
that can be activated include: DUN (Dial-Up Networking service), Printer (serial
service), and LANPPP (LANAccessUsingPPP service). ASync (ActiveSync) is
another available profile.
• To start the service scan, highlight a device in the Devices tab list, and then
click on the Services button or double-click on the device entry.
Note: If the remote device is out of reach or turned off, it can take a consider-
able amount of time for the Services dialog box to appear—it may appear
to be frozen.
Once the device's service profiles are displayed in the Services list box:
• Highlight the service to be activated.
• Press [SPACE] or right-click to display the Activation menu.
The Activation menu contains four options: Activate, Authenticate, Outgoing and
Encrypt.
118 Psion Teklogix 7535 G2 Hand-Held Computer User Manual