Figure 3-84: Caller Display Information - AudioCodes Media Pack MP-124 User Manual

SIP User's Manual

To configure the Caller Display Information:
1. Open the 'Caller Display Information' page (Configuration tab > Protocol
Configuration menu > Endpoint Settings submenu > Caller Display Information
page item).
2. In the' Caller ID/Name' field corresponding to the desired port, enter the Caller ID
string (up to 18 characters).
3. From the 'Presentation' drop-down list, select one of the following:
•
'Allowed' [0]
IP call is made using the corresponding device port.
•
'Restricted'
4. Click the
5. To save the changes to flash memory, refer to ''
Notes:
Version 5.8
Figure 3-84: Caller Display Information Page
- sends the string defined in the 'Caller ID/Name' field when a Tel-to-
[1] - the string defined in the 'Caller ID/Name' field is not sent.
Submit button to save your changes.
•
When FXS ports receive 'Private' or 'Anonymous' strings in the From
header, they don't send the calling name or number to the Caller ID
display.
•
If Caller ID name is detected on an FXO line (EnableCallerID = 1), it is
used instead of the Caller ID name defined on this page.
•
When the 'Presentation' field is set to 'Restricted', the Caller ID is sent to
the remote side using only the P-Asserted-Identity and P-Preferred-
Identity headers (AssertedIdMode).
•
To maintain backward compatibility, when the strings 'Private' or
'Anonymous' are entered in the 'Caller ID/Name' field, the Caller ID is
restricted and the value in the 'Presentation' field is ignored.
•
The value of the 'Presentation' field can be overridden by configuring the
'Presentation' field in the 'Source Number Manipulation' table (refer to
'' Configuring the Number Manipulation Tables''
•
You can also configure the Caller Display Information table using the ini
file table parameter CallerDisplayInfo.
Saving Configuration''
145
3. Web-Based Management
on page 167
on page 124 ).
September 2009
.