Configuring Basic Sip Parameters; Figure 5-3: Sip Protocol Definitions Frame - AudioCodes Media Pack MP-124 User Manual
Mediapack series voice over ip (voip) gateways
Hide thumbs
Also See for Media Pack MP-124:
- User manual (486 pages) ,
- Hardware installation manual (44 pages) ,
- User manual (584 pages)
Table of Contents
Advertisement
5.4
Configuring Basic SIP Parameters
This section describes how to configure the device with basic SIP control protocol
parameters using the EMS.
To configure basic SIP parameters:
1.
In the MG Tree, select the device that you want to configure.
2.
On the Tab bar, click Protocol Definition
appears.
3.
Select the Coders
a.
Click the
b.
Double-click each field to enter values.
c.
Right-click the new entry, and then choose Unlock Rows
4.
Select the
a.
Set 'Proxy Used' to Yes.
b.
(Optional) In the 'Proxy Name' field, enter the Proxy's name. The Proxy name
replaces the Proxy IP address in all SIP messages. This means that messages
are still sent to the physical Proxy IP address, but the SIP URI contains the Proxy
name instead. When no Proxy is used, the internal routing table is used to route
the calls.
c.
Click the
d.
Enter the IP address of the Proxy Server.
e.
Right-click the new entry, and then choose Unlock Rows.
SIP User's Manual
Figure 5-3: SIP Protocol Definitions Frame
tab; the Coders screen is displayed.
button to add a new Coder entry, and then click Yes
Proxy Server
tab.
button, and then click Yes
200
; the 'SIP Protocol Definitions' frame
.
to confirm.
Document #: LTRT-65412
MP-11x & MP-124
to confirm.
Advertisement
Table of Contents
Troubleshooting
