Figure 3-60: Proxy Sets Table; Table 3-16: Proxy Sets Table Parameters - AudioCodes Media Pack MP-124 User Manual


To add Proxy servers and configure Proxy parameters:
1. Open the 'Proxy Sets Table' page (Configuration tab > Protocol Configuration
menu > Proxies/IpGroups/Registration submenu > Proxy Sets Table
2. From the Proxy Set ID drop-down list, select an ID for the desired group.
3. Configure the Proxy parameters according to the following table.
4. Click the Submit
5. To save the changes to flash memory, refer to ''
Parameter
Web: Proxy Set ID
EMS: Index
[ProxySet_Index]
SIP User's Manual
Figure 3-60: Proxy Sets Table Page
button to save your changes.

Table 3-16: Proxy Sets Table Parameters

The Proxy Set identification number.
The valid range is 0 to 5 (i.e., up to 6 Proxy Set ID's can be
configured). The Proxy Set ID #0 is used as the default Proxy Set,
and if defined is backward compatible to the list of Proxies from
earlier releases.
Note: Although not recommended, you can use both default Proxy
Set (ID #0) and IP Groups for call routing. For example, on the
'Hunt Group Settings' page (refer to ''Configuring the Hunt Group
Settings'' on page
where you want to route specific HuntGroup's endpoints, while all
other device endpoints use the default Proxy Set. At the same, you
can also use IP Groups in the 'Tel to IP Routing' table (refer to
''Configuring the Tel to IP Routing Table''
configure the default Proxy Set if the parameter PreferRouteTable
is setto 1.
To summarize, if the default Proxy Set is used, the INVITE
96
Saving Configuration''
Description
150 ), you can configure a Serving IP Group to
on page
Document #: LTRT-65412
MP-11x & MP-124
page item).
on page 167 .
131 ) to